关于ATP中lis文件提示错误的更改

dongyangyang

You lose, fella.   The EMTP logic has detected an error condition, and is now going to terminate program execution.  The following
" D! F7 ^3 r* J- h# ~message summarizes the circumstances leading to this situation.  Where an otherwise-unidentified data card is referred to, or where
the "last" card is mentioned, it is the most recently read card of the input data that is meant.  The 80-column image of this card
1 j) g9 A" n5 t. _7 s7 Q; Nis generally the last one printed out prior to this termination message.  But possibly this last-read card has not yet been
- p. Z2 ]& t! T% C1 U3 Mdisplayed, so a copy follows:
3 D! R! _! Q% O9 }7 m% i* s "14X0044B 0    10500.       50.     -120.                           -1.        1."
+ H  \  F! Q  p% f              KILL code number                Overlay number               Nearby statement number
# n4 N1 S+ X$ P# V                         12                          5                               4246
. L4 }. P0 T! X- K" m0 e8 iKILL = 12.   The bus name that was read from columns 3-8 of the last source card is unrecognizable, not having been previously
defined by a branch card or a switch card.  The name read from the data card is  "X0044B".   The user is not allowed to connect
- ?. a4 [- K1 v+ j6 ^5 hsources to network nodes that are not a part of the network that was previously defined by branch and switch cards of this data
case.  Any such new node would be completely disconnected from the network, so could not affect the solution.  Most probably, one or
more spelling errors (including the positioning of imbedded blanks) have been made in the keying of one or more node names on EMTP
9 x* Q9 p. H+ y$ k4 Ldata cards.
那位老师可以帮我看看这是什么出现了问题。急用，谢谢！

nygyg

溢出了，程序的数组变量设小了，从ATP Launcher中将打开Tools-Make Tpbig.exe,选择Change Listsize将LPAST数值扩大10倍即可