LIS总是看不懂，哪位高人指点一下？

jymildred

You lose, fella.   The EMTP logic has detected an error condition, and is now going to terminate program execution.  The following
- `4 X5 v0 m+ c. `message summarizes the circumstances leading to this situation.  Where an otherwise-unidentified data card is referred to, or where
  y  s9 u0 s) k2 I' U- q3 {1 Ethe "last" card is mentioned, it is the most recently read card of the input data that is meant.  The 80-column image of this card
is generally the last one printed out prior to this termination message.  But possibly this last-read card has not yet been
displayed, so a copy follows:
"  X0005AX0005A                                        MEASURING                1"
( F7 g- l8 @( i              KILL code number                Overlay number               Nearby statement number
8 f) O! W" A7 @* ]0 \3 p                        224                          4                               8212
) C' m+ h# W( x2 q. K* gKILL = 224.   The last-read data card is for a switch that has both terminals connected to the same node  BUS1 = X0005A.   This is
/ x8 J" Q$ H3 O! {$ B/ r9 hobjectionably stupid.
哪位高人能说一下，上面是什么意思啊？自己总是琢磨不透，谢谢了~

螃蟹飞飞

他是说你的一个开关的两端连在同一个节点X0005A上面。。。。。。
“The last-read data card is for a switch that has both terminals connected to the same node  BUS1 = X0005A.   This is objectionably stupid.”

jymildred

[img]file:///C:/Documents%20and%20Settings/Administrator/Application%20Data/Tencent/Users/569290572/QQ/WinTemp/RichOle/$M7C37SG1[}N82_`K{8HKZQ.jpg[/img]
图如上该怎么改呢？我实在不明白。

jymildred

不好意思，不太会弄，这是图

silencelw

回复 4# jymildred
3 f9 S+ X$ y6 W5 l
: y0 c8 v$ w2 g* H: g( J
   你吧那个支路电流元件两端的连线拆了  然后一端连线路  一端连开关 试试  最好不要直接把电流测量元件直接放支路上

螃蟹飞飞

回复 4# jymildred 把电流互感器两端的名称改一下试试吧？名字不应该是一样的啊……