digsilent中模型开环测试设置完成后，如何运行？

wllszs

在一份资料中看到model搭建完成后可以不连接其他设备，进行开环测试，操作如下：
& G% J! x5 P9 w, ?' S! ?4 b0 @
         Verify the behaviour of the model by an open-loop test, i.e. the controller is not connected to any
2 x; f; p2 h8 ^/ o) Y* v# `' cother element (synchronous generator) in the grid:
9 X! d0 d/ _; z2 X0 i* F
Open-Loop Response:
 1    Test the model with a step response to the reference voltage “usetp” (open-loop-test) [17].
, |/ S! ~) w) y 2    Define a variable set to monitor for the VCO element and visualize the results of the simulated step response

上面第一步的具体操作过程：
#17: Open-Loop Test

1 O+ M2 g; s! `" e4 p# Q6 x+ k' y% Z# e 1     Open the event list ( ) and use the “New Object” button to insert a “Set Parameter(EvtPara)” event
( t  D5 `0 o, ~6 e2 [1 V7 x* ? 2     Select the AVR controller for the element.
7 j" v3 \& \3 k1 V, e 3     Insert the name of the variable ‘usetp’ and the new value for this variable (=0.9).

0 W' w1 O+ I9 v) X" `3 ~/ W 我想问的是，这些设置都做完后，接下来如何操作呢？

wllszs

补充：2    Define a variable set to monitor for the VCO element and visualize the results of the simulated step response

这一步也完成了，问：接下来怎么做？是执行计算初始条件然后开始仿真吗？

wzliniam

接下来就是定义一些你要观察的变量的值，然后做仿真，显示结果。

wlm_28

学习一下