IEEE30节点运行总是报错，哪里需要改各位大神？

Llinzi

警告: A propagation speed of 483775 km/s has been found for mode 2; Propagation speeds must be < 300000 km/s! [75 similar]
9 {9 p* Y/ [) ^: `$ C2 V! ?
Matching "From" for "Goto" 'IEEE30/B1-2/Iabc' not found [211 similar]
Component:Simulink | Category:Blockwarning
# h! D4 N5 z( K6 i4 qOutput port 5 of 'IEEE30/Power Plant  #4/Turbine & Regulators M2/Bus Selector' is not connected. [3 similar]
9 u  f  A6 v+ N7 a0 d  H3 b8 bComponent:Simulink | Category:Blockwarning
The block diagram 'IEEE30' uses bus signals or has signals/parameters that are associated with bus objects. However, the 'Mux blocks used to create bus signals' diagnostic is not configured to 'error'.
5 W* R5 A6 b4 l) ~! m, ]! A% o- j; A' u  Suggested Actions
Run the 'Check Bus Usage' check in Upgrade Advisor and follow the recommendations

8 z2 Y7 L' g" U. @* o
2 [( z2 @: G* E3 i6 B+ ?6 f8 P

Llinzi

主要是什么问题呢？