ATP中多个mov设置问题

xxh2jd

设置了两个mov ,出现以下问题。
You lose, fella.   The EMTP logic has detected an error condition, and is now going to terminate program execution.  The following
6 N+ D/ E1 B7 `3 M4 u8 e
; w2 s" F0 c9 C! gmessage summarizes the circumstances leading to this situation.  Where an otherwise-unidentified data card is referred to, or where
" j& N% o& C% Z# }/ ]' v" uthe "last" card is mentioned, it is the most recently read card of the input data that is meant.  The 80-column image of this card
is generally the last one printed out prior to this termination message.  But possibly this last-read card has not yet been
1 `3 ~' ]5 T9 k$ ]: ]% udisplayed, so a copy follows:
! d/ G9 K' m5 m "                                                                                "
- V6 D1 u! U! D4 B              KILL code number                Overlay number               Nearby statement number
                        209                         18                               3501
KILL = 209.   ZnO solution by Newton`s method of  2   coupled arresters has failed due to singularity of the Jacobian matrix.  This
3 m5 x% e: _# a* r) j7 V/ G! ]( qis measured by tolerance EPSILN,  which is defined by the floating-point miscellaneous data card.   The iteration count is  2,   and
+ W: ^  E1 X) J4 G2 y4 q! Ythe coupled group of arresters can be identified from the knowledge that the first (in order of input) connects bus  "XX0035"  with
bus  "XX0010".   The simulation time is  T = 1.00000000E-06.

% u6 C' j5 D  O! v; N

barnes

试一试把这个数字调大

stoat

把避雷器改成非线性电阻

986305096

stoat 发表于 2018-11-29 14:46
4 e  |/ `; {. @8 I1 i- ~把避雷器改成非线性电阻

$ o: F( w- z2 K* p这个可以设置串联间隙嘛

stoat

986305096 发表于 2019-12-31 10:53
& i5 u( S6 E$ P( M6 z- r这个可以设置串联间隙嘛

看你说的串联间隙有什么特性了，根据相应的数学模型进行建模