关于tline.exe的，高手必看

xuyufufzu

有谁知道tline.exe的程序流程的计算规则么，现在据说此系统的默认的参数设置是 100MVA 60Hz 230kv 基准值的处理过程，大家使用的时候，一定得小心的啊！

yizhangsjtu

The TLINE program is used to calculate parameters of traveling wave lines.
; m# A+ A6 s. U" R' {For different model, the algorithm are different.
For example the most often used Bergron line,
) G4 v: R* D: z+ [# `1 sThe results will be traveling time, surge impedance,Resistor and transformation matrix.
% @) x3 ~6 C1 [  Z6 [2 @- S4 BThe 230KV, 60Hz, 100MVA is default value display on the program.
You can change those anyway.
6 c! d7 L. c( f% kHowever, those three are not used in the program at all.
+ h3 O+ b2 g& y% {Therefore, whatever you type, just for yourself reference, tline.exe doesn't use it.
% \0 q( H3 `4 `5 A8 ?4 _1 yYou don't need to worry about it at all.
5 F4 ~9 j+ {) X/ dThere is some description of tline algorithm in chapter 4 of EMTP theory book.
Notice that tline.exe is written by EMTDC people, it may not be exactly the same as EMTP.
However, basic theory would be the same.

xuyufufzu

使用的时候，计算结果假设了R G 均为0 的啊，或者是采取了 Bergron 的数据模式 线路的周末两端均为人R/4 ，线路中间的为R/2，两端LC均为分布特性的传输线

nyguoqiang

这个倒是没有注意过
* ]# c, m4 ^* `8 l' D- f不过感觉不用担心吧
" s  ^$ F5 ]3 {: _$ r完全可以自己设置
我是这样理解的
请高手指点

yizhangsjtu

If the traveling time is larger than 2 time step, the above mentioned model is used.
If the traveling time is between 1 and 2 time step, the resistor is halfly lamped at two terminals.
- P( D' s) X1 }9 g2 M4 e) d; lIf the traveling time is smaller than 1 time step, the PI section has to be used, or the user has to reduce the time step.

xuyufufzu

受益了的啊，谢谢版主的了的啊

zhoushaoxing

没有用过，不过感谢楼主的提醒。