防雷的仿真为什么加入避雷器以后会运行出错

liushuaige0919

You lose, fella.   The EMTP logic has detected an error condition, and is now going to terminate program execution.  The following
- P0 Y4 }: f2 k: e' v  xmessage summarizes the circumstances leading to this situation.  Where an otherwise-unidentified data card is referred to, or where
the "last" card is mentioned, it is the most recently read card of the input data that is meant.  The 80-column image of this card
* k* J. }3 \4 l6 his generally the last one printed out prior to this termination message.  But possibly this last-read card has not yet been
displayed, so a copy follows:
"                                                                                "
* L0 o" [' R  ]& B% b              KILL code number                Overlay number               Nearby statement number
                        212                         18                               3522
KILL = 212.   A Newton solution for  1   coupled nonlinear elements has failed to converge within the iteration limit  MAXZNO = 50.
- Y' Q. ?7 _' p, w( sThe current residual is  2.28977187E+06,  which exceeds the sloppy convergence tolerance  EPSTOP = 1.00000000E-01.   The first of
the coupled, true, nonlinear elements (in order of data input) is located in row  1   of the nonlinear element table, and it
connects node  "      "  with node  "XX0002".   The final coupled element is in row  1,   and the matrix rank is  1.   Finally, the
simulation time is  T = 1.00000000E-06.   Possible corrective actions include a decrease in the time-step size  DELTAT,  an increase
/ G* M7 D" S2 N, a1 ?: e$ I( nin the iteration limit  MAXZNO,  an increase in the divergence tolerance  EPSTOP,  and artificial splitting of the subnetwork  in
; \! K$ X4 h8 z9 B* ~3 kquestion by distributed-parameter lines (to reduce the number of coupled elements).   In addition, it is possible for the user to
make a solution impossible by unrealistically limiting the Newton corrections.  The user should remember that there can be no
solution if his bound on arrester voltage is less than the true solution voltage.  The bound has a default value of 1.5 per unit,
although it can be changed by a"ZINC OXIDE"  special request (columns 57-64, variable  ZLIN(2)).
1 o! G4 F8 K, h6 M- O; _
6 w2 W1 s0 I$ B. ]1 t& V3 `' u以上去错误代码，有哪位大神能指点一下，避雷器模型哪里设置不对？
9 a, Q0 Z% p7 L4 i: \1 [$ V9 r

我是小火龙

我也出现过这个问题，你把参考电压重新设置一下看看

guozh07

这样提问，有心帮你也没办法呀！
' r: B3 ?9 i0 y( {6 y  y6 T