jymildred 发表于 2012-8-8 19:44:40

LIS总是看不懂，哪位高人指点一下？

You lose, fella.   The EMTP logic has detected an error condition, and is now going to terminate program execution.The following
message summarizes the circumstances leading to this situation.Where an otherwise-unidentified data card is referred to, or where
the "last" card is mentioned, it is the most recently read card of the input data that is meant.The 80-column image of this card
is generally the last one printed out prior to this termination message.But possibly this last-read card has not yet been
displayed, so a copy follows:
"X0005AX0005A                                        MEASURING                1"
            KILL code number                Overlay number               Nearby statement number
                        224                        4                               8212
KILL = 224.   The last-read data card is for a switch that has both terminals connected to the same nodeBUS1 = X0005A.   This is
objectionably stupid.
哪位高人能说一下，上面是什么意思啊？自己总是琢磨不透，谢谢了~

螃蟹飞飞 发表于 2012-8-8 21:01:01

他是说你的一个开关的两端连在同一个节点X0005A上面。。。。。。
“The last-read data card is for a switch that has both terminals connected to the same nodeBUS1 = X0005A.   This is objectionably stupid.”

jymildred 发表于 2012-8-8 21:24:43

file:///C:/Documents%20and%20Settings/Administrator/Application%20Data/Tencent/Users/569290572/QQ/WinTemp/RichOle/$M7C37SG1[}N82_`K{8HKZQ.jpg
图如上该怎么改呢？我实在不明白。

jymildred 发表于 2012-8-8 21:26:02

不好意思，不太会弄，这是图

silencelw 发表于 2012-8-10 10:59:13

回复 4# jymildred


   你吧那个支路电流元件两端的连线拆了然后一端连线路一端连开关 试试最好不要直接把电流测量元件直接放支路上

螃蟹飞飞 发表于 2012-8-16 22:44:03

回复 4# jymildred 把电流互感器两端的名称改一下试试吧？名字不应该是一样的啊……
页: [1]
查看完整版本: LIS总是看不懂，哪位高人指点一下？

招聘斑竹