变压器分接头控制和line drop compensation怎么实现啊
最近在做变压器控制的relay，怎么样实现延迟60秒再调节呢？或者谁做过这个求分享...多谢~~ On-Line Tap ChangerAll transformer components are equipped with an on-line tap changer.When the tap changer is enabled, a diagonal line will appear on the component graphic, labelled Tap.
A change in tap setting is modeled as a change in the turns-ratio of the transformer.The per-unit leakage reactance and magnetizing currents, specified for 100% tap, are used to calculate admittances for the new voltage rating, corresponding to the tap setting.
EXAMPLE:
Let us assume for simplicity, that a transformer is configured as Y-Y, with winding voltages rated at 10 kV primary and 100 kV secondary, and a tap changer is placed on the primary winding.The turns-ratio for this transformer is of course 1:10.
An on-line tap input of 1.0 corresponds to a 100% tap (i.e. no tap adjustment).If the tap input value is adjusted to say 1.05, then the turns-ratio would become 1.05:10 or 1:9.52381.
It is possible to have a continuous change of tap, but this would require a re-ordering of the network solution every time step. It is more practical to change tap settings in steps, either through manual adjustment, using a slider or rotary switch, or from a controller with appropriate delays and steps built in.
RE: 变压器分接头控制和line drop compensation怎么实现啊
回复 2# mingyuThanks a lot for the reply and explanation...do you have any pscad example about OLTC control? 没有，找客服要。 没做过，不太清楚呀
页:
[1]
