ATP-EMTP谐波模块数据溢出如何解决？
仿真可以正常运行，但只要加入谐波分析模块就显示如下错误。已经用ATP-Launcher修改了存储数组大小，但是不知道修改哪一个求大佬指点！！！
Execution of the program is interrupted in the MODELS section of the data case.
The model in use is identified by the following use pathname:
MODELS.HARMONICS
------------------------------------------------------------------------------------------------------------------------------------
ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/
ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/
------------------------------------------------------------------------------------------------------------------------------------
You lose, fella. The EMTP logic has detected an error condition, and is now going to terminate program execution.The following
message summarizes the circumstances leading to this situation.Where an otherwise-unidentified data card is referred to, or where
the "last" card is mentioned, it is the most recently read card of the input data that is meant.The 80-column image of this card
is generally the last one printed out prior to this termination message.But possibly this last-read card has not yet been
displayed, so a copy follows:
" "
KILL code number Overlay number Nearby statement number
644 13 9999
KILL = 644.The real storage area is overflowing into the real stack.Increase the storage allocation for MODELS.
number of used real storage cells as this point = 557818
number of used real stack cells at this point = -349458
页:
[1]
