防雷的仿真为什么加入避雷器以后会运行出错
You lose, fella. The EMTP logic has detected an error condition, and is now going to terminate program execution.The followingmessage summarizes the circumstances leading to this situation.Where an otherwise-unidentified data card is referred to, or where
the "last" card is mentioned, it is the most recently read card of the input data that is meant.The 80-column image of this card
is generally the last one printed out prior to this termination message.But possibly this last-read card has not yet been
displayed, so a copy follows:
" "
KILL code number Overlay number Nearby statement number
212 18 3522
KILL = 212. A Newton solution for1 coupled nonlinear elements has failed to converge within the iteration limitMAXZNO = 50.
The current residual is2.28977187E+06,which exceeds the sloppy convergence toleranceEPSTOP = 1.00000000E-01. The first of
the coupled, true, nonlinear elements (in order of data input) is located in row1 of the nonlinear element table, and it
connects node" "with node"XX0002". The final coupled element is in row1, and the matrix rank is1. Finally, the
simulation time isT = 1.00000000E-06. Possible corrective actions include a decrease in the time-step sizeDELTAT,an increase
in the iteration limitMAXZNO,an increase in the divergence toleranceEPSTOP,and artificial splitting of the subnetworkin
question by distributed-parameter lines (to reduce the number of coupled elements). In addition, it is possible for the user to
make a solution impossible by unrealistically limiting the Newton corrections.The user should remember that there can be no
solution if his bound on arrester voltage is less than the true solution voltage.The bound has a default value of 1.5 per unit,
although it can be changed by a"ZINC OXIDE"special request (columns 57-64, variableZLIN(2)).
以上去错误代码，有哪位大神能指点一下，避雷器模型哪里设置不对？
我也出现过这个问题，你把参考电压重新设置一下看看 这样提问，有心帮你也没办法呀！
页:
[1]
