silencelw 发表于 2013-4-30 12:05:37

请高手指点——仿真出现问题

------------------------------------------------------------------------------------------------------------------------------------
ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/
ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/
------------------------------------------------------------------------------------------------------------------------------------
You lose, fella.   The EMTP logic has detected an error condition, and is now going to terminate program execution.The following
message summarizes the circumstances leading to this situation.Where an otherwise-unidentified data card is referred to, or where
the "last" card is mentioned, it is the most recently read card of the input data that is meant.The 80-column image of this card
is generally the last one printed out prior to this termination message.But possibly this last-read card has not yet been
displayed, so a copy follows:
"                                                                              "
            KILL code number                Overlay number               Nearby statement number
                        744                         13                               9999
KILL = 744.The time value supplied to the function delay(var,time,pol) presently refers to a future time of the simulation.The
function may only be applied to past times.Use the function predval to predict the value of a variable at a future simulation
time.
      function name, argument name =
         DELAY, UBP
      array index value = 1
      present simulation time = 0.00000000E+00
      supplied time value = 1.66666667E-07
------------------------------------------------------------------------------------------------------------------------------------
ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/
ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/ERROR/
------------------------------------------------------------------------------------------------------------------------------------

请大家踊跃发表意见   改怎么修改   这个是仿真配网感应过电压的

cxxgtxy 发表于 2013-4-30 16:43:40

请发求助帖

cxxgtxy 发表于 2013-4-30 16:46:57

感觉意义不大

cxxgtxy 发表于 2013-4-30 19:44:32

估计只有发求助帖，才会有人理你

redplum 发表于 2013-5-2 00:47:44

感觉比较杂乱，很难一下再看清楚
页: [1]
查看完整版本: 请高手指点——仿真出现问题

招聘斑竹