ATP或者PSCAD求教瞬间接地电弧怎么仿真
做双回线的仿真,线路瞬间接地,产生的燃弧,一次电弧和二次电弧怎样建模?
有知道的吗?请指教::smile:: 不胜感激-%-51696-%--%-26259-%--%-51886-%- As far as I know,the arc are not seriously in ATP or PSCAD. There are two reasons that cause this situation. One is the arc model is not clear. Especially for those people who wrote ATP and PSCAD, they are normally power system guys, while arc are normally fell intothe area of high voltage engineering. The second reason is the EMTP type program are normally used to analysis the phenomenon up to 5k Hz. But the arc may cover much high frequency response, which is beyond the frequency range anyway. yizhangsjtu 发表于 2007-9-25 06:11
As far as I know,the arc are not seriously in ATP or PSCAD. There are two reasons that cause this si ...
learn a lot from you. thank you sincerely. 这是一个接地电弧的模型,也是从这个论坛下载的。希望对楼主有用 电弧的模型就可以,我现在一点头绪也没有,望指点 呵呵,加油哟............ 关于ATP的问题,有谁有相关资料呀,能否共享一下,谢谢 原帖由 yizhangsjtu 于 2007-9-25 06:11 发表 https://tech.cepsc.com/images/common/back.gif
As far as I know,the arc are not seriously in ATP or PSCAD. There are two reasons that cause this situation. One is the arc model is not clear. Especially for those people who wrote ATP and PSCAD, the ...
You can use PSCAD to model arc phenomenon