ATP中多个mov设置问题
设置了两个mov ,出现以下问题。You lose, fella. The EMTP logic has detected an error condition, and is now going to terminate program execution.The following
message summarizes the circumstances leading to this situation.Where an otherwise-unidentified data card is referred to, or where
the "last" card is mentioned, it is the most recently read card of the input data that is meant.The 80-column image of this card
is generally the last one printed out prior to this termination message.But possibly this last-read card has not yet been
displayed, so a copy follows:
" "
KILL code number Overlay number Nearby statement number
209 18 3501
KILL = 209. ZnO solution by Newton`s method of2 coupled arresters has failed due to singularity of the Jacobian matrix.This
is measured by tolerance EPSILN,which is defined by the floating-point miscellaneous data card. The iteration count is2, and
the coupled group of arresters can be identified from the knowledge that the first (in order of input) connects bus"XX0035"with
bus"XX0010". The simulation time isT = 1.00000000E-06.
试一试把这个数字调大 把避雷器改成非线性电阻::lol:: stoat 发表于 2018-11-29 14:46
把避雷器改成非线性电阻
这个可以设置串联间隙嘛
986305096 发表于 2019-12-31 10:53
这个可以设置串联间隙嘛
看你说的串联间隙有什么特性了，根据相应的数学模型进行建模
页:
[1]
